Step one would be to first obtain the correct sort of interfacing that will work for you form of interfacing fabric. Mostly these instructions is going to be on the rear of the pattern envelope that you simply bought. When you are creating your own personal patterns in your own home, it would be best to first test what interfacing will work on the type of fabric you will be using. You merely want a small component of fabric and measure a block, fuse the piece and measure it again to see what the different shrinkage was.
Now in my opinion which is doing sewing both at home and like a hobby I don’t use a fusing press or fusing machine like most clothing manufactures have. I still need to use to old reliable method that worked for me personally.
The various tools that you just would need will be the following:
3. Correct interfacing
I know other folks use more equipment having said that i have been using this technique for many years and do not had any problems.
Steps to follow along with:
1. Remove your patterns items of the material and interfacing. Many people will claim that you cutout you interfacing smaller compared to you interlining fabric supplier then when you steam iron it, it won’t adhere to your cloth or ironing board. That depends on you, you will know best how accurate you work.
2. Make sure before ironing the various components together that the glue dotted side are facing a bad side of your fabric. This is certainly quite important part as if you iron the parts together and it’s the incorrect sides it tough to eliminate the interfacing again, probably also depend upon the kind of interfacing and glue.
3. Place a cloth on the parts and ensure you iron is hot. I found that steam doesn’t always work efficiently thus i just use a small amount of steam setting in the iron. I use a cloth as a fabbric iron can leave shiny marks on non woven fusible interfacing and you also don’t want that.
4. When pressing the iron on top of the cloth make it for several seconds on a single spot before moving onto another section. I also do small sections at the same time irrespective of how small the parts are.
5. After ironing the parts let it sit to cool off for a bit before working with it to continue sewing your garment. I think it is advisable to fuse each of the interfacing parts prior to actually start sewing the garment.